Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.
Standard level AC protection and filtering.
Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet.
Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only).
All settings and configurations available on rear panel.
15 amp rating.
Three year limited warranty.
Maximum Output Current
15 amps, 120 VAC (Thermal breaker)
14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R, Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex), 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
Standard level AC Surge Protection
Merit Class (sacrificial)
Spike Protection Mode
Line to neutral, zero ground leakage
Max Continuous Operating Voltage
Max Clamp Voltage
500 Volts Peak
Peak Impulse Current
Energy Rating (2 X 820Î¼S)
Standard level Pi LCR Filter
>26dB, 100 Khz to 1 MHz
Operating Temperature Range
5C (40F) to 40C (105F) degrees
<90% rH (Relative Humidity)
Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker
Front panel, push to reset
Front Panel Indicators
Delay 1, Delay 2, Delay 3, Power, Protection OK
Rear Panel DIP Switches
12V Mode On/Off, GND Mode On, Momentary/Maintained
Rear panel, time calibration fine tune delay adjust
+5-30VDC In, 12VDC (12mA) Out
Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
19"L x 8.75"D x 1.75"H â€" ANSI 1RU
(1) Furman M-8S Power Sequencer (1) Operator's Instructions